I was visiting with the foundry today when we found my Ampico A
transmission frame patterns.  I went ahead and ordered some to be cast
in 320 brass [leaded red brass] (not the cheapest material).  I _do not_
plan on machining any of these any time soon but I am willing to sell
just the casting ($35.00) if you are a pretty decent machinist.

The response to the rubber motor mounts was really a surprise to me and
I want to thank those of you that responded.  I would like to once again
point out that this is just a strip of rubber that you have to cut to
width and drill the holes.

Don Teach - Shreveport Music Co.
Shreveport, Louisiana